This paper describes an experimental investigation of the elastohydrodynamic problem. The investigation was limited to a study of nominal point contacts in pure sliding motion. The profile of the lubricant film separating the bearing surfaces was determined during a transient of the normal load. During this transient the Hertzian contact stresses were increased from zero to a maximum of 150,000 lbf/in2 in approximately 45 milli-secs. The sliding velocities used in this study were varied from 13.7 to 92.1 ips. The resulting mean shear rate, however, was typically 107 reciprocal seconds. Both pure and polymer-blended naphthenic and paraffinic oils, in addition to several synthetic fluids, were studied. On the basis of the film thickness profiles obtained for the polymer-blended oils, it was concluded that the ambient value of viscosity often used in theoretical considerations does not characterize the behavior of the system. It was also found that the rapid application of the normal load had a negligible effect on the film thickness profile. During this investigation the contact traction was also measured. The results of those measurements are reported in the companion paper, “Fluid Rheological Effects in Sliding Elastohydrodynamic Point Contacts With Transient Loading: II—Traction.”
Skip Nav Destination
Article navigation
April 1971
This article was originally published in
Journal of Lubrication Technology
Research Papers
Fluid Rheological Effects in Sliding Elastohydrodynamic Point Contacts With Transient Loading: 1—Film Thickness
D. M. Sanborn,
D. M. Sanborn
School of Mechanical Engineering, Georgia Institute of Technology, Atlanta, Ga.
Search for other works by this author on:
W. O. Winer
W. O. Winer
School of Mechanical Engineering, Georgia Institute of Technology, Atlanta, Ga.
Search for other works by this author on:
D. M. Sanborn
School of Mechanical Engineering, Georgia Institute of Technology, Atlanta, Ga.
W. O. Winer
School of Mechanical Engineering, Georgia Institute of Technology, Atlanta, Ga.
J. of Lubrication Tech. Apr 1971, 93(2): 262-270 (9 pages)
Published Online: April 1, 1971
Article history
Received:
July 16, 1970
Online:
October 18, 2010
Article
Article discussed|
View article
Connected Content
A companion article has been published:
Fluid Rheological Effects in Sliding Elastohydrodynamic Point Contacts With Transient Loading: 2—Traction
Citation
Sanborn, D. M., and Winer, W. O. (April 1, 1971). "Fluid Rheological Effects in Sliding Elastohydrodynamic Point Contacts With Transient Loading: 1—Film Thickness." ASME. J. of Lubrication Tech. April 1971; 93(2): 262–270. https://doi.org/10.1115/1.3451560
Download citation file:
Get Email Alerts
Cited By
Static Characteristics of Hybrid Water-Lubricated Herringbone Groove Journal Bearing
J. Tribol (April 2025)
Related Articles
Transient Elastohydrodynamic Lubrication Film Thickness During Normal Approach Considering Shear-Thinning and Linear Piezoviscous Oils
J. Tribol (April,2015)
The Shear-Thinning Elastohydrodynamic Film Thickness of a Two-Component Mixture
J. Tribol (April,2008)
Rheology of Dilute Polymer Solutions and Engine Lubricants in High Deformation Rate Extensional Flows Produced by Bubble Collapse
J. Fluids Eng (March,2004)
An Investigation Into the Influence of Fluid Viscoelasticity in a Squeeze Film Bearing
J. of Lubrication Tech (January,1978)
Related Proceedings Papers
Related Chapters
Processing/Structure/Properties Relationships in Polymer Blends for the Development of Functional Polymer Foams
Advances in Multidisciplinary Engineering
General and Historical Information
Pipeline Integrity Assurance: A Practical Approach
Use and Development of Biodegradable Oils
Tribology of Mechanical Systems: A Guide to Present and Future Technologies