Results of a combined theoretical and experimental investigation into the operation of thrust bearings with polytetrafluoroethylene (PTFE)-faced pads are reported. Bearing performance is analyzed in terms of temperature, power loss, oil film thickness and pressure. These parameters are first calculated using a THD model. The effect of PTFE facing on bearing thermal performance is then presented and discussed. A TEHD model is subsequently employed. Obtained TEHD results show that oil film thickness and temperature are strongly affected by the PTFE layer. Theoretical results are compared with measured temperature, oil film thickness, and pressure.
Issue Section:
Research Papers
1.
Soifer
, A. M.
, Kodnir
, D. S.
, and Baiborodov
, Yu. I.
, 1965
, “Elastic Sliding Bearing on a Base of Resilient Deformable Material Combined With Fluoroplastic
,” Izv. VUZov, Mashinostroenie
, 7
, pp. 67
–69
.2.
Baiborodov
, Yu. I.
et al., 1977
, “Operating Experience With Elastic Metal-Plastic Pads in a Thrust Bearing Unit N 9 of Volga Hydropower Station Named After V. I. Lenin
,” Gidrotekh. Stroit.
, 10
, pp. 28
–31
.3.
Glavatskih
, S. B.
, 2003
, “Evaluating Thermal Performance of a PTFE-Faced Tilting Pad Thrust Bearing
,” J. Tribol.
, 125
, pp. 319
–324
.4.
Ettles
, C. M.
, Knox
, R. T.
, Ferguson
, J. H.
, and Horner
, D.
, 2003
, “Test Results for PTFE-Faced Thrust Pads, With Direct Comparison Against Babbitt-Faced Pads and Correlation With Analysis
,” J. Tribol.
, 125
, pp. 814
–823
.5.
Fillon, M., Souchet, D., and Fre^ne, J., 1990, “Influence of Bearing Element Displacements on Thermohydrodynamic Characteristics of Tilting-Pad Journal Bearings,” Proceedings of the 1990 International Tribology Conference, Nagoya, JAST, pp. 635–640.
6.
Glavatskih
, S. B.
, Fillon
, M.
, and Larsson
, R.
, 2002
, “The Significance of Oil Thermal Properties on the Performance of a Tilting-Pad Thrust Bearing
,” ASME J. Tribol.
, 124
, pp. 377
–385
.7.
Rades
, M.
, 1972
, “Dynamic Analysis of an Inertial Foundation Model
,” Int. J. Solids Struct.
, 8
, pp. 1353
–1372
.8.
Pascovici
, M. D.
, and Suciu
, C. V.
, 1992
, “Analytical Investigation of a Narrow Compliant Journal Bearing
,” Acta Tribologyca
, 1
, pp. 89
–93
.9.
Lin
, C. R.
, and Rylander
, H. G.
, 1991
, “Performance Characteristics of Compliant Journal Bearings
,” ASME J. Tribol.
, 113
, pp. 639
–644
.10.
Boncompain
, R.
, Fillon
, M.
, and Fre^ne
, J.
, 1986
, “Analysis of Thermal Effects in Hydrodynamic Bearings
,” ASME J. Tribol.
, 108
, pp. 219
–224
.11.
Glavatskih
, S. B.
, 2002
, “Laboratory Research Facility for Testing Hydrodynamic Thrust Bearings
,” Proc. Inst. Mech. Eng., Part J: J. Eng. Tribol.
, 216
, pp. 105
–116
.12.
Glavatskih
, S. B.
, 2004
, “A Method of Temperature Monitoring in Fluid Film Bearings
,” Tribol. Int.
, 37
, pp. 134
–148
.Copyright © 2006
by ASME
You do not currently have access to this content.