In the search for new, more effective coolant fluids, nanoparticle suspensions have shown promise due to their enhanced thermal conductivity. However, there is a concomitant increase in the viscosity, requiring an increase in pumping power to achieve the same flow rate. Studies of flow cooling in simple geometries indicate that there is a benefit to using nanofluids, but it is difficult to justify extending these results to the far more complicated geometries. Moreover, with the variability of property measurements found in literature, it is possible to show conflicting results from the same set of flow-cooling data. In this work we present a self-contained study of the properties and effectiveness of an alumina in water nanofluid. Flow-cooling is studied in an off-the-shelf fluid cooling package for electronics to examine the effects of the particulates in a practical scenario. We measure the thermal conductivity and viscosity of the same suspensions to assure consistent interpretation of our results. We find that, while there is no anomalous enhancement of the thermal properties or transport, there is a benefit to using a low volume fraction alumina nanoparticle suspension over using the base fluid alone. In fact, there is an optimal volume fraction (1%) for this nanofluid and electronics cooling system combination that maximizes the heat dissipated. However, we find that this benefit decreases as the volume fraction, and hence the viscosity, increases. Understanding where the trade-off between viscosity increase and thermal conductivity increase occurs is critical to designing an electronics cooling system using a nanofluid as a coolant.
Skip Nav Destination
Article navigation
September 2009
Research Papers
Nanofluid Properties and Their Effects on Convective Heat Transfer in an Electronics Cooling Application
Rebecca J. Christianson
Rebecca J. Christianson
Franklin W. Olin College of Engineering
, Needham, MA 02492
Search for other works by this author on:
Jessica Townsend
Rebecca J. Christianson
Franklin W. Olin College of Engineering
, Needham, MA 02492J. Thermal Sci. Eng. Appl. Sep 2009, 1(3): 031006 (9 pages)
Published Online: March 16, 2010
Article history
Received:
October 18, 2009
Revised:
January 22, 2010
Online:
March 16, 2010
Published:
March 16, 2010
Citation
Townsend, J., and Christianson, R. J. (March 16, 2010). "Nanofluid Properties and Their Effects on Convective Heat Transfer in an Electronics Cooling Application." ASME. J. Thermal Sci. Eng. Appl. September 2009; 1(3): 031006. https://doi.org/10.1115/1.4001123
Download citation file:
Get Email Alerts
Cited By
Simulation and Experimental Study of Two-Phase Gas–Liquid Behavior in Two-Dimensional Porous Medium Based on Lattice Boltzmann Method
J. Thermal Sci. Eng. Appl (February 2025)
Effect of Variation of the Aspect Ratio of Rectangular Twisted Tapes Inserted in a Circular Pipe on the Thermal Performance
J. Thermal Sci. Eng. Appl (February 2025)
Design Optimization of a Shell-and-Tube Heat Exchanger Based on Variable Baffle Cuts and Sizing
J. Thermal Sci. Eng. Appl (February 2025)
Energy-Efficient Three-Wheel Bleedless Electrical Environmental Control System for a Passenger Aircraft
J. Thermal Sci. Eng. Appl (February 2025)
Related Articles
On the Cooling of Electronics With Nanofluids
J. Heat Transfer (May,2011)
Experimental Investigation of Turbulent Convective Heat Transfer and Pressure Loss of Alumina/Water and Zirconia/Water Nanoparticle Colloids (Nanofluids) in Horizontal Tubes
J. Heat Transfer (April,2008)
Heat Transfer Augmentation of Aqueous Suspensions of Nanodiamonds in Turbulent Pipe Flow
J. Heat Transfer (April,2009)
Optimization of Free Convection Heat Transfer From Vertical Plates Using Nanofluids
J. Heat Transfer (April,2012)
Related Proceedings Papers
Related Chapters
Completing the Picture
Air Engines: The History, Science, and Reality of the Perfect Engine
Thermal Design Guide of Liquid Cooled Systems
Thermal Design of Liquid Cooled Microelectronic Equipment