Alloys 617 and 230 are currently identified as two leading candidate metallic materials in the down selection for applications at temperatures above in the Gen IV nuclear reactor systems. Qualifying the materials requires significant information related to codification, mechanical behavior modeling, metallurgical stability, environmental resistance, and many other aspects. In the present paper, material requirements for the Gen IV nuclear reactor systems are discussed; available information regarding the two alloys for the intended applications are reviewed and analyzed; and further R&D activities are suggested. In the United States the major requirement for qualifying the materials is to satisfy the ASME Subsection NH, with adequate considerations for NRC, ASME NQA-1, and Section XI. In comparison, Alloy 617 is more studied with larger existing databases in air and helium, while Alloy 230 may have highly desired potentials but needs more exploration. To provide a sound technical basis for the material selection decision, more data should be generated to characterize behaviors of both alloys in creep, loading rate sensitivity, fatigue, creep-fatigue, crack resistance, toughness, product form dependency, and metallurgical stability.
Skip Nav Destination
e-mail: renw@ornl.gov
Article navigation
August 2009
Technology Review
A Review on Current Status of Alloys 617 and 230 for Gen IV Nuclear Reactor Internals and Heat Exchangers 1
Weiju Ren,
Weiju Ren
Metals Science and Technology Division,
e-mail: renw@ornl.gov
Oak Ridge National Laboratory
, MS-6155, Building 4500-S, Oak Ridge, TN 37831
Search for other works by this author on:
Robert Swindeman
Robert Swindeman
Search for other works by this author on:
Weiju Ren
Metals Science and Technology Division,
Oak Ridge National Laboratory
, MS-6155, Building 4500-S, Oak Ridge, TN 37831e-mail: renw@ornl.gov
Robert Swindeman
J. Pressure Vessel Technol. Aug 2009, 131(4): 044002 (15 pages)
Published Online: May 26, 2009
Article history
Received:
August 13, 2007
Revised:
February 24, 2009
Published:
May 26, 2009
Citation
Ren, W., and Swindeman, R. (May 26, 2009). "A Review on Current Status of Alloys 617 and 230 for Gen IV Nuclear Reactor Internals and Heat Exchangers ." ASME. J. Pressure Vessel Technol. August 2009; 131(4): 044002. https://doi.org/10.1115/1.3121522
Download citation file:
Get Email Alerts
The Behavior of Elbow Elements at Pure Bending Applications Compared to Beam and Shell Element Models
J. Pressure Vessel Technol (February 2025)
Related Articles
A Review Paper on Aging Effects in Alloy 617 for Gen IV Nuclear Reactor Applications
J. Pressure Vessel Technol (April,2009)
Mechanical and Microstructural Performance Evaluation of Diffusion Bonded Alloy 800H for Very High Temperature Nuclear Service
J. Eng. Mater. Technol (April,2022)
High-Temperature Fatigue/Creep/Environment Interactions in Compressor Alloys
J. Eng. Gas Turbines Power (January,2003)
Extension of Fatigue Exemption Rules in Section VIII, Division 2 Slightly Into the Creep Regime
J. Pressure Vessel Technol (April,2012)
Related Proceedings Papers
Related Chapters
Division 5—High Temperature Reactors
Online Companion Guide to the ASME Boiler & Pressure Vessel Codes
Division 5—High Temperature Reactors
Companion Guide to the ASME Boiler and Pressure Vessel Codes, Volume 1, Fifth Edition
Creep-Fatigue Analysis
Design & Analysis of ASME Boiler and Pressure Vessel Components in the Creep Range