The purpose of this study was to analyze the impact of blades with slots in a rotary compressor. The equations for contact forces were derived from Newton’s law. Updated moving Lagrangian descriptions with the hybrid technique and the Newark time integration method were used to determine the nodal displacement vectors. The finite element method was used to analyze the contact forces and the stresses of blades. The maximum blade contact force of 2.3 KN was larger than the maximum static force of 1 KN. The maximum blade impact Von Mises stress of 12.3 Mpa that occurred at the contact point was greater than the previous calculated static stress of 5.15 Mpa. Hence, the impact effect was significant. Experimental modal analysis was also used to determine the first and second natural frequencies of blades.
Skip Nav Destination
Article navigation
December 2001
Technical Papers
The Impact of Sliding Blades in a Rotary Compressor
Yung-Shane Liaw, Research Assistant
Yung-Shane Liaw, Research Assistant
Department of Mechanical Engineering, National Taiwan University, Taipei, Taiwan 10674 Republic of China
Search for other works by this author on:
Yung-Shane Liaw, Research Assistant
Department of Mechanical Engineering, National Taiwan University, Taipei, Taiwan 10674 Republic of China
Contributed by the Design Automation Committee for publication in the JOURNAL OF MECHANICAL DESIGN. Manuscript received April 1999. Associate Editor: H. Lankarani.
J. Mech. Des. Dec 2001, 123(4): 583-589 (7 pages)
Published Online: April 1, 1999
Article history
Received:
April 1, 1999
Citation
Huang, Y. M., and Liaw, Y. (April 1, 1999). "The Impact of Sliding Blades in a Rotary Compressor ." ASME. J. Mech. Des. December 2001; 123(4): 583–589. https://doi.org/10.1115/1.1416150
Download citation file:
Get Email Alerts
Cited By
DeepJEB: 3D Deep Learning-Based Synthetic Jet Engine Bracket Dataset
J. Mech. Des (April 2025)
Design and Justice: A Scoping Review in Engineering Design
J. Mech. Des (May 2025)
Related Articles
Rotordynamic Analysis of a Large Industrial Turbocompressor Including Finite Element Substructure Modeling
J. Eng. Gas Turbines Power (August,2010)
Determination of Contact Stiffness of Rod-Fastened Rotors Based on Modal Test and Finite Element Analysis
J. Eng. Gas Turbines Power (September,2010)
Component-Mode-Based Reduced Order Modeling Techniques for Mistuned Bladed Disks—Part II: Application
J. Eng. Gas Turbines Power (January,2001)
A Linearized Theory on Ground-Based Vibration Response of Rotating Asymmetric Flexible Structures
J. Vib. Acoust (June,2006)
Related Proceedings Papers
Related Chapters
Outlook
Closed-Cycle Gas Turbines: Operating Experience and Future Potential
Modal Analysis of a New Magnetic Levitation Stage Based on Finite Element Simulation
International Conference on Mechanical Engineering and Technology (ICMET-London 2011)
Stress Analysis of Gas Turbine Blade under Different Loads Using Finite Element Modeling
International Conference on Mechanical and Electrical Technology, 3rd, (ICMET-China 2011), Volumes 1–3