The approaches traditionally used to quantify creep and creep fracture are critically assessed and reviewed in relation to a new approach proposed by Wilshire and Scharning. The characteristics, limitations, and predictive accuracies of these models are illustrated by reference to information openly available for the bainitic 1Cr–1Mo–0.25V steel. When applied to this comprehensive long-term data set, the estimated 100,000–300,000 h strength obtained from the older so called traditional methods varied considerably. Further, the isothermal predictions from these models became very unstable beyond 100,000 h. In contrast, normalizing the applied stress through an appropriate ultimate tensile strength value not only reduced the melt to melt scatter in rupture life, but also the 100,000 h strengths determined from this model for this large scale test program are predicted very accurately by extrapolation of creep life measurements lasting less than 5000 h. The approach therefore offers the potential for reducing the scale and cost of current procedures for acquisition of long-term engineering design data.
Skip Nav Destination
e-mail: m.evans@swansea.ac.uk
Article navigation
April 2009
Research Papers
Critical Review and Appraisal of Traditional and New Procedures for the Quantification of Creep Fracture Behavior Using 1Cr–1Mo–0.25V Steel
M. Evans
M. Evans
School of Engineering,
e-mail: m.evans@swansea.ac.uk
Swansea University
, Singleton Park, Swansea SA2 8PP, UK
Search for other works by this author on:
M. Evans
School of Engineering,
Swansea University
, Singleton Park, Swansea SA2 8PP, UKe-mail: m.evans@swansea.ac.uk
J. Eng. Mater. Technol. Apr 2009, 131(2): 021011 (14 pages)
Published Online: March 9, 2009
Article history
Received:
September 15, 2008
Revised:
December 11, 2008
Published:
March 9, 2009
Citation
Evans, M. (March 9, 2009). "Critical Review and Appraisal of Traditional and New Procedures for the Quantification of Creep Fracture Behavior Using 1Cr–1Mo–0.25V Steel." ASME. J. Eng. Mater. Technol. April 2009; 131(2): 021011. https://doi.org/10.1115/1.3078391
Download citation file:
Get Email Alerts
Cited By
Modeling Growth and Viscous Flow of Oxide on Cylindrical Silicon Surfaces Including Piezoviscous Inhibition
J. Eng. Mater. Technol (April 2025)
Thermal Conductivity of 3D-Printed Metal Using Extrusion-Based Metal Additive Manufacturing Process
J. Eng. Mater. Technol (April 2025)
Related Articles
Prediction of Ductile-to-Brittle Transition Under Different Strain Rates in Undermatched Welded Joints
J. Pressure Vessel Technol (June,2011)
High and Low-Cycle Fatigue Behavior of Prestressed Concrete in Offshore Structures
J. Energy Resour. Technol (March,1980)
A Review Paper on Aging Effects in Alloy 617 for Gen IV Nuclear Reactor Applications
J. Pressure Vessel Technol (April,2009)
Related Chapters
Introduction and Definitions
Handbook on Stiffness & Damping in Mechanical Design
Compromise between Tensile and Fatigue Strength
New Advanced High Strength Steels: Optimizing Properties
Section VIII: Division 2–Alternative Rules
Companion Guide to the ASME Boiler & Pressure Vessel Codes, Volume 2, Sixth Edition