In this paper, the effect of the reference misalignment on the tooth measurements of an involute spur gear is examined. Analytical relations between the profile/lead traces and the reference misalignment parameters are derived. These relations can be employed to estimate the misalignment parameters when three or more profile and lead traces are available. The estimated parameters may be subsequently used to remove the effect of the reference misalignment on the profile and lead traces. Experiments are conducted to verify the proposed method and to illustrate the applications of the developed approach.
Issue Section:Technical Papers
Topics:Gear teeth, Gears, Inspection, Spur gears, Errors
AGMA 390. 03, 1980, AGMA Gear Handbook, Volume 1, American Gear Manufacturer’s Association, Alexandria, VA.
Laskin, I., Smith, R. E., and Lawson, E., 1993, “Effect of Radial Runout on Element Measurement,” Proceedings of 1993 AGMA Fall Technical Meeting, Paper No. 93FTM6.
Och, R., 1996, “Gear and Spline Measuring Abilities at the Shop Floor,” Proceedings of International Conference on Gears, Dresden, Germany, pp. 647–659.
Yan Z. C., 1994, “Geometric Tolerance Evaluation and Uncertainty Analysis for Coordinate Metrology,” Ph.D. Dissertation, The Ohio State University.
Foley, J. D., van Dam, A., Feiner, S. K., Hughes, J. F., and Phillips, R. L., 1986, Introduction to Computer Graphics, Addison-Wesley Publishing Company.
Colbourne, J. R., 1987, The Geometry of Involute Gear, Springer-Verlag, pp. 179–184, pp. 208–228.
Su, X., 1999, Generation, Measurement and Reverse Engineering of Three-Dimensional Gears, Ph.D. Dissertation, The Ohio State University.
Houser, D. R., Oswald, F. B., Valco, M. J., Drago, R. J., and Lenski Jr., J. W., 1994, “Comparison of Transmission Error Predictions with Noise Measurements for Several Spur and Helical Gears,” Proceedigns, 30th AIAA/ASME/SAE/ASEE Joint Propulsion Conference, AIAA Paper #94-3366.
Copyright © 2002