This paper describes a methodology of online measuring and compensating spindle error motions without using a precalibrated master. The method is based on a combination of forecasting compensatory control (FCC) and error separation techniques. The real time recursive ARMA modeling technique is used for the modeling and forecasting of workpiece errors while the error compensation is performed by means of two-dimensional piezo-actuated tool movements. Experimental results have shown that an improvement of 42–47 percent was achieved for the roundness error of workpieces in the taper turning operations.
A New Method for Roundness Control in Taper Turning Using FCC Techniques
Contributed by the Manufacturing Engineering Division for publication in the JOURNAL OF MANUFACTURING SCIENCE AND ENGINEERING. Manuscript received June 1999; revised Sept. 2000. Associate Editor: R. Furness.
- Views Icon Views
- Share Icon Share
- Search Site
Fung, E. H. K., and Yang, S. M. (September 1, 2000). "A New Method for Roundness Control in Taper Turning Using FCC Techniques ." ASME. J. Manuf. Sci. Eng. November 2001; 123(4): 567–575. https://doi.org/10.1115/1.1372196
Download citation file: