This paper reports results from an experimental study of boiling heat transfer during quenching of a cylindrical copper disk by a subcooled, circular, free-surface water jet. The disk was heated to approximately 650°C, and as quenching occurred, transient temperature measurements were taken at discrete locations near the surface and applied as boundary conditions in a conduction model to deduce transient heat flux distributions at the surface. Results are presented in the form of heat flux distributions and boiling curves for radial locations varying from the stagnation point to ten nozzle diameters for jet velocities between 2.0 and 4.0 m/s Data for nucleate boiling in the stagnation region and spatial distributions of maximum heat flux are presented and are in good agreement with correlations developed from steady-state experiments. Spatial distributions of minimum film boiling temperatures and heat fluxes are also reported and reveal a fundamental dependence on jet deflection and streamwise location. A companion paper (Hall et al., 2001) describes single-phase and boiling heat transfer measurements from a two-phase (water-air), free-surface, circular jet produced by injecting air bubbles into the jet upstream of the nozzle exit.
Skip Nav Destination
Article navigation
Technical Papers
Jet Impingement Boiling From a Circular Free-Surface Jet During Quenching: Part 1—Single-Phase Jet
David E. Hall,
David E. Hall
Michelin Americas Research Corporation, 515 Michelin Road, Greenville, SC 29602
Search for other works by this author on:
Frank P. Incropera,
Frank P. Incropera
Notre Dame University, South Bend, IN 46556
Search for other works by this author on:
Raymond Viskanta
Raymond Viskanta
School of Mechanical Engineering, Purdue University, West Lafayette, IN 47907
Search for other works by this author on:
David E. Hall
Michelin Americas Research Corporation, 515 Michelin Road, Greenville, SC 29602
Frank P. Incropera
Notre Dame University, South Bend, IN 46556
Raymond Viskanta
School of Mechanical Engineering, Purdue University, West Lafayette, IN 47907
Contributed by the Heat Transfer Division for publication in the JOURNAL OF HEAT TRANSFER. Manuscript received by the Heat Transfer Division May 27, 1997; revision received March 22, 2001. Associate Editor: M. S. Sohal.
J. Heat Transfer. Oct 2001, 123(5): 901-910 (10 pages)
Published Online: March 22, 2001
Article history
Received:
May 27, 1997
Revised:
March 22, 2001
Citation
Hall, D. E., Incropera, F. P., and Viskanta, R. (March 22, 2001). "Jet Impingement Boiling From a Circular Free-Surface Jet During Quenching: Part 1—Single-Phase Jet ." ASME. J. Heat Transfer. October 2001; 123(5): 901–910. https://doi.org/10.1115/1.1389061
Download citation file:
Get Email Alerts
Cited By
Related Articles
Jet Impingement Boiling From a Circular Free-Surface Jet During Quenching: Part 2—Two-Phase Jet
J. Heat Transfer (October,2001)
Critical Heat Flux of Steady Boiling for Subcooled Water Jet Impingement on the Flat Stagnation Zone
J. Heat Transfer (April,2004)
Simultaneous Boiling Visualization and Heat Transfer Measurement of Two Adjacent Water Impinging Jets
J. Heat Transfer (August,2016)
Numerical Simulation of Evaporating Two-Phase Flow in a High-Aspect-Ratio Microchannel with Bends
J. Heat Transfer (August,2017)
Related Chapters
Liquid Cooled Systems
Thermal Management of Telecommunications Equipment
Thermal Design Guide of Liquid Cooled Systems
Thermal Design of Liquid Cooled Microelectronic Equipment
Liquid Cooled Systems
Thermal Management of Telecommunication Equipment, Second Edition