Experimental test results for flow boiling of pure ammonia inside horizontal tubes were obtained for a plain stainless steel tube. Tests were run at a nominal saturation temperature of 4°C, nine mass velocities from 20–140 kg/m2 s, vapor qualities from 1–99 percent and heat fluxes from 5–58 kW/m2. Two-phase flow observations showed that the current test data covered the following regimes: fully stratified, stratified-wavy, intermittent, annular, and annular with partial dryout. The Kattan-Thome-Favrat flow boiling model accurately predicted the local heat transfer coefficients measured in all these flow regimes with only two small modifications to their flow map (to extend its application to G < 100 kg/m2 s). Their flow boiling model was also successfully compared to the earlier ammonia flow boiling data of Chaddock and Buzzard (1986). The Gungor-Winterton (1987) correlation instead gave very poor accuracy for ammonia.

1.
Chaddock
J.
, and
Buzzard
G.
,
1986
, “
Film Coefficients for In-Tube Percentages of Mineral Oil
,”
ASHRAE Trans.
, Vol.
92
, Part 1A, pp.
22
40
.
2.
Collier, J. G., and Thome, J. R., 1994, Convective Boiling and Condensation, 3rd Ed., Oxford University Press, Oxford, UK.
3.
Cooper, M. K., 1984, “Saturated Nucleate Pool Boiling: A Simple Correlation,” 1st U.S. National Heat Transfer Conference, Vol. 2, pp. 785–793.
4.
Gungor
K. E.
, and
Winterton
R. H. S.
,
1986
, “
A General Correlation for Flow Boiling in Tubes and Annuli
,”
Int. J. Heat Mass Transfer
, Vol.
29
, pp.
351
358
.
5.
Gungor
K. E.
, and
Winterton
R. H. S.
,
1987
, “
Simplified General Correlation for Saturated Flow Boiling and Comparisons of Correlations with Data
,”
Chem. Eng. Res. Des.
, Vol.
65
, pp.
148
156
.
6.
Jung
D. S.
,
McLinden
M.
,
Radermacher
R.
,
Didion
D.
,
1989
, “
A Study of Flow Boiling Heat Transfer with Refrigerant Mixtures
,”
Int. J. Heat Mass Transfer
, Vol.
32
, No.
9
, pp.
1751
1764
.
7.
Kandlikar
S. G.
,
1990
, “
A General Correlation of Saturated Two-Phase Flow Boiling Heat Transfer Inside Horizontal and Vertical Tubes
,”
ASME JOURNAL OF HEAT TRANSFER
, Vol.
112
, pp.
219
228
.
8.
Kattan
N.
,
Thome
J. R.
, and
Favrat
D.
,
1998
a, “
Flow Boiling in Horizontal Tubes, Part 1: Development of a Diabatic Two-Phase Flow Pattern Map
,”
ASME JOURNAL OF HEAT TRANSFER
, Vol.
120
, pp.
140
147
.
9.
Kattan
N.
,
Thome
J. R.
, and
Favrat
D.
,
1998
b, “
Flow Boiling in Horizontal Tubes, Part 2: New Heat Transfer Data for Five Refrigerants
,”
ASME JOURNAL OF HEAT TRANSFER
, Vol.
120
, pp.
148
155
.
10.
Kattan
N.
,
Thome
J. R.
, and
Favrat
D.
,
1998
c, “
Flow Boiling in Horizontal Tubes, Part 3: Development of a New Heat Transfer Model Based on Flow Patterns
,”
ASME JOURNAL OF HEAT TRANSFER
, Vol.
120
, pp.
156
165
.
11.
Nidegger
E.
,
Thome
J. R.
, and
Favrat
D.
,
1997
, “
Flow Boiling and Pressure Drop Measurements for R-134a/Oil Mixtures, Part 1: Evaporation in a Microfin Tube
,”
HVAC&R Research, ASHRAE
, Vol.
3
, No.
1
, pp.
38
53
.
12.
Rouhani
Z.
, and
Axelsson
E.
,
1970
, “
Calculation of Volume Void Fraction in the Subcooled and Quality Region
,”
Int. J. Heat Mass Transfer
, Vol.
13
, pp.
383
393
.
13.
Shah
M. M.
,
1975
, “
Visual Observations in an Ammonia Evaporator
,”
ASHRAE Trans.
, Vol.
81
, Part 1, pp.
295
306
.
14.
Shah
M. M.
,
1982
, “
Chart Correlation for Saturated Boiling Heat Transfer: Equations and Further Study
,”
ASHRAE Trans.
, Vol.
88
, Part 1, pp.
185
196
.
15.
Steiner, D., 1993, “Heat Transfer to Boiling Saturated Liquids,” V Dl-Wa¨rmeatlas (VDI Heat Atlas), Editor: Verein Deutscher Ingenieure, VDI-Gessellschaft Verfahrenstechnik und Chemie-ingenieurwesen (GCV), Translator: J. W. Fullarton, Du¨sseldorf.
16.
Thome
J. R.
,
1996
, “
Boiling of New Refrigerants: A State-of-the-Art Review
,”
Int. J. Refrig.
, Vol.
19
, No.
7
, pp.
435
457
.
17.
Zu¨rcher, O., Thome, J. R., and Favrat, D., 1997a, “Prediction of Two-Phase Flow Patterns for Evaporation of Refrigerant R-407C inside Horizontal Tubes,” Convective Flow and Pool Boiling Conference, Klo¨ster Irsee, Germany, May 18-23, Paper IX-1.
18.
Zu¨rcher
O.
,
Thome
J. R.
, and
Favrat
D.
,
1997
b, “
Intube Flow Boiling of R-407C and R-407C/Oil Mixtures—Part II: Plain Tube Results and Predictions
,”
J. HVAC&R Research
, ASHRAE, Vol.
4
, No.
4
, pp.
373
399
.
This content is only available via PDF.
You do not currently have access to this content.