Issue Section:
Technical Briefs
1.
Baughn, J. W., and Yan, X., 1991, “A Preheated-Wall Transient Method for Measurements of the Heat Transfer to an Impinging Jet,” Eurotherm Seminar No. 25, pp. 1–7.
2.
Baughn
J. W.
Yan
X.
Roby
Jon L.
1994
, “An Insertion Technique Using the Transient Method with Liquid Crystals for Enhanced Heat Transfer Measurements in Ducts
,” Enhanced Heat Transfer
, Vol. 1
, No. 2
, pp. 179
–180
.3.
Baughn
J. W.
1995
, “Liquid Crystal Methods for Studying Turbulent Heat Transfer
,” International Journal of Heat and Fluid Flow
, Vol. 16
, pp. 365
–375
.4.
Butler
R. J.
Baughn
J. W.
1995
, “A Shroud Technique Using the Transient Method for Local Heat Transfer Measurements
,” Experimental Heat Transfer
, Vol. 8
, No. 1
, pp. 17
–32
.5.
Butler
R. J.
Baughn
J. W.
1996
, “The Effect of the Thermal Boundary Condition on Transient Method Heat Transfer Measurements on a Flat Plate With a Laminar Boundary Layer
,” ASME JOURNAL OF HEAT TRANSFER
, Vol. 118
, pp. 831
–837
.6.
Camci
C.
Kim
K.
Hippensteele
S. A.
1992
, “A New Hue Capturing Technique for the Quantitative Interpretation of Liquid Crystal Images Used in Convective Heat Transfer Studies
,” ASME Journal of Turbomachinery
, Vol. 114
, pp. 765
–775
.7.
Camci
C.
Kim
K.
Hippensteele
S. A.
Poinsatte
P. E.
1993
, “Evaluation of a Hue Capturing Based Transient Liquid Crystal Method for High-Resolution Mapping of Convective Heat Transfer on Curved Surfaces
,” ASME JOURNAL OF HEAT TRANSFER
, Vol. 115
, pp. 311
–318
.8.
Clifford, R. J., Jones, T. V., and Dunne, S. T., 1983, “Techniques for Obtaining Detailed Heat Transfer Coefficient Measurements Within Gas Turbine Blade and Vane Cooling Passages,” ASME Paper 83-GT-58.
9.
Farina, D. J., Hacker, J. M., Moffat, R. J., and Eaton, J. K., 1993, “Illuminant Invariant Calibration of Thermochromic Liquid Crystals,” Visualization of Heat Transfer Processes, Vol. 252, 252, J. J. Simoneau and B. F. Armaly, eds., pp. 1–11.
10.
Hay
J. L.
Hollingsworth
D. K.
1996
, “A Comparison of Trichromic Systems for Use in the Calibration of Polymer-Dispersed Thermochromic Liquid Crystals
,” Exp. Thermal Fluid Science
, Vol. 12
, pp. 1
–12
.11.
Ireland, P. T., and Jones, T. V., 1985, “The Measurement of Local Heat Transfer Coefficients in Blade Cooling Geometries,” AGARD Conference Proceedings, No. 390, Paper 28.
12.
Ireland, P. T., and Jones, T. V., 1986, “Detailed Measurements of Heat Transfer On and Around a Pedestal in Fully Developed Passage Flow,” 8th International Heat Transfer Conference, Vol. 3, pp. 975–980.
13.
Jones, T. V., and Hippensteele, S. A., 1987, “High-Resolution Heat-Transfer Coefficient Maps Applicable to Compound Curve Surfaces Using Liquid Crystals in a Transient Wind Tunnel,” Development in Experimental Technique in Heat Transfer and Combustion, (also NASA TM-89855, 1988).
14.
Metzger
D. E.
Larson
E. E.
1986
, “Use of Melting Point Surface Coatings for Local Convective Heat Transfer Measurements in Rectangular Channel Flows With 90-Deg. Turns
,” ASME JOURNAL OF HEAT TRANSFER
, Vol. 108
, pp. 48
–54
.15.
Metzger
D. E.
Bunker
R. S.
Bosch
G.
1991
, “Transient Liquid Crystal Measurement of Local Heat Transfer on a Rotating Disk With Jet Impingement
,” ASME Journal of Turbomachinery
, Vol. 113
, pp. 52
–59
.16.
O’Brien, J. E., Simoneau, R. J., LaGraff, J. E., and Morehouse, K. A., 1986, “Unsteady Heat Transfer and Direct Comparison for Steady-State Measurements in a Rotor-Wake Experiment,” 8th International Heat Transfer Conference, San Francisco, pp. 1243–1248.
This content is only available via PDF.
Copyright © 1998
by The American Society of Mechanical Engineers
You do not currently have access to this content.