An experimental study of heat transfer and flow regimes during condensation of refrigerants in horizontal tubes was conducted. Measurements were made in smooth, round tubes with diameters ranging from 3.14 mm to 7.04 mm. The refrigerants tested were R-12, R-22, R-134a, and near-azeotropic blends of R-32/R-125 in 50 percent/50 percent and 60 percent/40 percent compositions. The study focused primarily on measurement and prediction of condensing heat transfer coefficients and the relationship between heat transfer coefficients and two-phase flow regimes. Flow regimes were observed visually at the inlet and outlet of the test condenser as the heat transfer data were collected. Stratified, wavy, wavy annular, annular, annular mist, and slug flows were observed. True mist flow without a stable wall film was not observed during condensation tests. The experimental results were compared with existing flow regime maps and some corrections are suggested. The heat transfer behavior was controlled by the prevailing flow regime. For the purpose of analyzing condensing heat transfer behavior, the various flow regimes were divided into two broad categories of gravity-dominated and shear-dominated flows. In the gravity dominated flow regime, the dominant heat transfer mode was laminar film condensation in the top of the tube. This regime was characterized by heat transfer coefficients that depended on the wall-to-refrigerant temperature difference but were nearly independent of mass flux. In the shear-dominated flow regime, forced-convective condensation was the dominant heat transfer mechanism. This regime was characterized by heat transfer coefficients that were independent of temperature difference but very dependent on mass flux and quality. Heat transfer correlations that were developed for each of these flow regimes successfully predicted data from the present study and from several other sources.
Skip Nav Destination
e-mail: j-chato@uiuc.edu
Article navigation
Research Papers
Condensation in Smooth Horizontal Tubes
M. K. Dobson,
M. K. Dobson
Exxon Production Research Co., Houston, TX 77252
Search for other works by this author on:
J. C. Chato
J. C. Chato
Department of Mechanical and Industrial Engineering, University of Illinois at Urbana-Champaign, 1206 W. Green Street, Urbana, IL 61801
e-mail: j-chato@uiuc.edu
Search for other works by this author on:
M. K. Dobson
Exxon Production Research Co., Houston, TX 77252
J. C. Chato
Department of Mechanical and Industrial Engineering, University of Illinois at Urbana-Champaign, 1206 W. Green Street, Urbana, IL 61801
e-mail: j-chato@uiuc.edu
J. Heat Transfer. Feb 1998, 120(1): 193-213 (21 pages)
Published Online: February 1, 1998
Article history
Received:
August 19, 1996
Revised:
August 4, 1997
Online:
January 7, 2008
Citation
Dobson, M. K., and Chato, J. C. (February 1, 1998). "Condensation in Smooth Horizontal Tubes." ASME. J. Heat Transfer. February 1998; 120(1): 193–213. https://doi.org/10.1115/1.2830043
Download citation file:
Get Email Alerts
Cited By
Entropic Analysis of the Maximum Output Power of Thermoradiative Cells
J. Heat Mass Transfer
Molecular Dynamics Simulations in Nanoscale Heat Transfer: A Mini Review
J. Heat Mass Transfer
Related Articles
Effect of Fog Formation on Turbulent Vapor Condensation With Noncondensable Gases
J. Heat Transfer (February,1996)
Film Condensation of R-11 Vapor on Single Horizontal Enhanced Condenser Tubes
J. Heat Transfer (February,1990)
Condensation of Ethylene Glycol on Horizontal Integral-Fin Tubes
J. Heat Transfer (November,1988)
Related Proceedings Papers
Related Chapters
Condensation in Cool Roofs—Code Challenges, Field Observations, and Hygrothermal Modeling
Roofing Research and Standards Development: 10th Volume
Evaluation of Moisture Accumulation in Composite Roof Decks in High Humidity Environments such as Natatoriums in Cold Climates Using Hygrothermal Modeling
Roofing Research and Standards Development: 10th Volume
Multiphase Flow Simulations of Sediment Particles in Mixed-flow Pumps
Mixed-flow Pumps: Modeling, Simulation, and Measurements