When a liquid film falls from one horizontal tube to another below it, the flow may take the form of discrete droplets, jets, or a continuous sheet; the mode plays an important role in the wetting and heat transfer characteristics of the film. Experiments are reported that explore viscous, surface tension, inertial, and gravitational effects on the falling-film mode transitions. New flow classifications, a novel flow regime map, and unambiguous transition criteria for each of the mode transitions are provided. This research is part of an overall study of horizontal-tube, falling-film flow and heat transfer, and the results may have important implications on the design and operation of falling-film heat exchangers.

Issue Section:
Falling Film Heat Transfer
Keywords:
Flow Instability, Forced Convection, Multiphase Flows
Topics:
Flow (Dynamics), Heat transfer, Design, Drops, Flow instability, Forced convection, Heat exchangers, Jets, Liquid films, Multiphase flow, Surface tension, Wetting
1.
Armbruster, R., and Mitrovic, J., 1994, “Patterns of Falling-Film Flow Over Horizontal Smooth Tubes,” Proc. Tenth International Heat Transfer Conference, Vol. 3, pp. 275–280.
2.
Armbruster, R., and Mitrovic, J., 1995, “Heat Transfer in Falling Film on a Horizontal Tube,” Proc. 1995 National Heat Transfer Conference—Vol. 12, ASME HTD-Vol. 314, pp. 13–21.
3.
Beaton, C. F., and Hewitt, G. F., 1988, Physical Property Data for the Design Engineer, Hemisphere, Washington, DC.
4.
Bejan, A., 1994, Convective Heat Transfer, Wiley-Interscience, New York.
5.
Chen
M. M.
,
1961
, “
An Analytical Study of Laminar Film Condensation: Part II—Single and Multiple Horizontal Tubes
,”
ASME JOURNAL OF HEAT TRANSFER
, Vol.
83
, pp.
55
–
60
.
6.
Dhir, V. K., and Taghavi-Tafreshi, K., 1981, “Hydrodynamic Transition During Dripping of a Liquid From Underside of a Horizontal Tube,” ASME Paper No. 81-WA/HT-12.
7.
Fletcher, L. S., Sernas, V., and Parken, W. H., 1975, “Evaporation Heat Transfer Coefficients for Thin Sea Water Films on Horizontal Tubes,” Industrial Engineering Chemistry, Progress Des. Dev., Vol. 14, pp. 411–416.
8.
Fujii, T., 1983, “Condensation in Tube Banks,” The Institute of Chemical Engineers Symposium Series, Vol. 75, pp. 3–23.
9.
Ganic
E. N.
, and
Roppo
M. N.
,
1980
, “
An Experimental Study of Falling Liquid Film Breakdown on a Horizontal Cylinder During Heat Transfer
,”
ASME JOURNAL OF HEAT TRANSFER
, Vol.
102
, pp.
342
–
346
.
10.
Honda, H., Nozu, S., and Takeda, Y., 1987, “Flow Characteristics of Condensate on a Vertical Column of Horizontal Tubes,” Proc. 1987 ASME–JSME Thermal Engineering Joint Conference, Honolulu, HI, Vol. 1, pp. 517–524.
11.
Honda
H.
,
Uchima
B.
,
Nozu
S.
,
Nakata
H.
, and
Torigoe
E.
,
1991
, “
Film Condensation of R-113 on In-Line Bundles of Horizontal Finned Tubes
,”
ASME JOURNAL OF HEAT TRANSFER
, Vol.
113
, pp.
479
–
486
.
12.
Hu, X., 1995, “The Intertube Falling-Film Modes: Transition, Hysteresis, and Effect on Heat Transfer,” Ph.D. Thesis, University of Illinois at Urbana-Champaign, Urbana, IL.
13.
Kern
D. Q.
,
1958
, “
Mathematical Development of Tube Loading in Horizontal Condensers
,”
AIChE Journal
, Vol.
4
, pp.
157
–
160
.
14.
Kutateladze
S. S.
,
Gogonin
I. I.
, and
Sosunov
V. I.
,
1985
, “
The Influence of Condensate Flow Rate on Heat Transfer in Film Condensation of Stationary Vapour on Horizontal Tube Banks
,”
International Journal of Heat and Mass Transfer
, Vol.
28
, pp.
1011
–
1018
.
15.
Maron-Moalem
D.
,
Sideman
S.
, and
Dukler
A. E.
,
1978
, “
Dripping Characteristics in a Horizontal Tube Film Evaporator
,”
Desalination
, Vol.
27
, pp.
117
–
127
.
16.
Marto
P. J.
,
1986
, “
Recent Progress in Enhancing Film Condensation Heat Transfer on Horizontal Tubes
,”
Heat Transfer Engineering
, Vol.
7
, pp.
53
–
63
.
17.
Mitrovic, J., 1986, “Influence of Tube Spacing and Flow Rate on Heat Transfer From a Horizontal Tube to a Falling Liquid Film,” Proc. 8th International Heat Transfer Conference, San Francisco, Vol. 4, pp. 1949–1956.
18.
Nicol, A. A., and Abdelghaffar, M., 1988, “A Theory for Condensation with Drainage,” Proc. 2nd UK National Conference of Heat Transfer, Glasgow, Vol. 1, pp. 639–651.
19.
Parken, W. H., 1975, “Heat Transfer to Thin Water Films on Horizontal Tubes,” Ph.D. Dissertation, Rutgers University, NJ.
20.
Rogers, J. T., Goindi, S. S., and Lamari, M., 1995, “Turbulent Falling Film Flow and Heat Transfer on Horizontal Tubes,” Proc. 1995 National Heat Transfer Conference—Vol. 12, ASME HTD-Vol. 314, pp. 3–12.
21.
Slayzak
S. J.
,
Viskanta
R.
, and
Incropera
F. P.
,
1994
, “
Effects of Interactions Between Adjoining Rows of Circular, Free-Surface Jets on Local Heat Transfer From the Impingement Surface
,”
ASME JOURNAL OF HEAT TRANSFER
, Vol.
116
, pp.
88
–
95
.
22.
Yundt
B.
, and
Rhinesmith
R.
,
1981
, “
Horizontal Spray-Film Evaporation
,”
Chemical Engineering Proceedings
, Vol.
77
, pp.
69
–
73
.
23.
Yung
D.
,
Lorentz
J. J.
, and
Ganic
E. N.
,
1980
, “
Vapor/Liquid Interaction and Entrainment in Falling Film Evaporators
,”
ASME JOURNAL OF HEAT TRANSFER
, Vol.
102
, pp.
20
–
25
.
This content is only available via PDF.
Copyright © 1996
 by The American Society of Mechanical Engineers
You do not currently have access to this content.