This investigation has examined the influence of spent air exits located between the jets on the magnitude and uniformity of the local heat transfer coefficient for a confined 3×3 square array of axisymmetric air jets impinging normally to a heated surface. The heat transfer coefficient was measured using a 0.025-mm-thick stainless steel impingement surface coated with liquid crystals. The temperature distribution along the surface was determined by measuring the reflected wavelength of light from the liquid crystal with the use of bandpass filters and an electronic digitizer board. The effect of small nozzle-to-plate spacings (0.25 and 1.0 diameters) commonly used in material processing applications was also considered. Average Nusselt numbers are presented for a Reynolds number range of 3500 to 20,400 along with radial distributions of the local Nusselt number. The local Nusselt number distributions illustrate the uniformity of the convective heat transfer coefficient and contribute to understanding the variations in the magnitude of the average Nusselt number. Results have shown that the addition of spent air exits increased the convective heat transfer coefficient and changed the location of the optimal separation distance. In addition, significant enhancement of the uniformity and magnitude of the heat transfer coefficient was observed at the 0.25 and 1.0 jet diameter nozzle-to-plate spacings when compared to a 6.0 diameter spacing.
Skip Nav Destination
Article navigation
Research Papers
Convective Heat Transfer to a Confined Impinging Array of Air Jets With Spent Air Exits
A. M. Huber,
A. M. Huber
Heat Transfer Laboratory, School of Mechanical Engineering, Purdue University, West Lafayette, IN 47907
Search for other works by this author on:
R. Viskanta
R. Viskanta
Heat Transfer Laboratory, School of Mechanical Engineering, Purdue University, West Lafayette, IN 47907
Search for other works by this author on:
A. M. Huber
Heat Transfer Laboratory, School of Mechanical Engineering, Purdue University, West Lafayette, IN 47907
R. Viskanta
Heat Transfer Laboratory, School of Mechanical Engineering, Purdue University, West Lafayette, IN 47907
J. Heat Transfer. Aug 1994, 116(3): 570-576 (7 pages)
Published Online: August 1, 1994
Article history
Received:
March 1, 1993
Revised:
September 1, 1993
Online:
May 23, 2008
Citation
Huber, A. M., and Viskanta, R. (August 1, 1994). "Convective Heat Transfer to a Confined Impinging Array of Air Jets With Spent Air Exits." ASME. J. Heat Transfer. August 1994; 116(3): 570–576. https://doi.org/10.1115/1.2910908
Download citation file:
Get Email Alerts
Cited By
Related Articles
Local Convective Heat Transfer From a Heated Surface to a Planar Jet of Water With a Nonuniform Velocity Profile
J. Heat Transfer (November,1990)
Investigation of the Effects of Flow Swirl on Heat Transfer Inside a Cylindrical Cavity
J. Heat Transfer (May,1991)
Effect of Entrainment on the Heat Transfer to a Heated Circular Air Jet Impinging on a Flat Surface
J. Heat Transfer (August,1990)
Means to Improve the Heat Transfer Performance of Air Jet Arrays Where Supply Pressures are Limiting
J. Heat Transfer (August,1998)
Related Chapters
Mixed-Up Convection
Hot Air Rises and Heat Sinks: Everything You Know about Cooling Electronics Is Wrong
Hydraulic Resistance
Heat Transfer & Hydraulic Resistance at Supercritical Pressures in Power Engineering Applications
Heat Transfer Enhancement by Using Nanofluids in Laminar Forced Convection Flows Considering Variable Properties
Proceedings of the 2010 International Conference on Mechanical, Industrial, and Manufacturing Technologies (MIMT 2010)