Measurement of film thickness between piston ring and cylinder bore has been a challenge for decades; laser-induced fluorescence (LIF) method was used by several groups, and promising results are obtained for the investigation of lubricant film transport. In this study, blue light generated by a laser source is transmitted to a beam splitter by means of a fiber optic cable and combined with another fiber optic line, then transmitted to the piston ring and cylinder bore conjunction. The light causes the fluorescence dye present in the lubricant to emit light in a longer wavelength, i.e., green. Reflected light is recollected; blue wavelength components are filtered out using a narrow band pass optical filter, and only components in the florescence wavelength is transmitted to a photomultiplier tube. The photomultiplier produces a voltage proportional to instantaneous lubricant film thickness. Then, the photomultiplier signal is calibrated for lubricant film thickness using a laser textured cylinder bore with known geometries. Additional marks were etched on the liner for calibration. The LIF system is adapted to a piston ring and cylinder bore friction test system simulating engine conditions. Static piston ring and reciprocating liner configuration of the bench test system allow the collection of continuous lubricant film thickness data as a function of crank angle position. The developed system has potential to evaluate new designs, materials, and surface properties in a controlled and repeatable environment.

References

1.
Tung
,
S. C.
, and
Gao
,
H.
,
2003
, “
A Study of Break-In Film Development With Different Piston Ring Coatings and Correlation With Electrical Contact Resistance Measurements
,”
Tribol. Trans.
,
46
(
3
), pp.
326
331
.
2.
Tamminen
,
J.
,
Sandstroma
,
E.
, and
Andersson
,
P.
,
2006
, “
Influence of Load on the Tribological Conditions in Piston Ring and Cylinder Liner Contacts in a Medium-Speed Diesel Engine
,”
Tribol. Int.
,
39
(
12
), pp.
1643
1652
.
3.
Takiguchi
,
M.
,
Sasaki
,
R.
,
Takahashi
,
I.
, and
Ishibashi
,
F.
,
2000
, “Oil Film Thickness Measurement and Analysis of a Three Ring Pack in an Operating Diesel Engine,”
SAE
Paper No. 2000-01-1787.
4.
Dellis
,
P. C.
,
2010
, “
Effect of Friction Force Between Piston Rings and Liner: A Parametric Study of Speed, Load, Temperature, Piston-Ring Curvature, and High-Temperature, High-Shear Viscosity
,”
Proc. Inst. Mech. Eng., Part J
,
224
(5), pp.
411
425
.
5.
Avan
,
E. Y.
,
Spencer
,
A.
,
Dwyer-Joyce
,
R. S.
,
Almqvist
,
A.
, and
Larsson
,
R.
,
2012
, “
Experimental and Numerical Investigations of Oil Film Formation and Friction in a Piston Ring–Liner Contact
,”
Proc. Inst. Mech. Eng., Part J
,
227
(
2
), pp.
126
140
.
6.
Smart
,
A. E.
, and
Ford
,
R. A. J.
,
1974
, “
Measurement of Thin Liquid Films by a Fluorescence Technique
,”
Wear
,
29
(
1
), pp.
41
47
.
7.
Ting
,
L. L.
,
1980
, “
Development of a Laser Fluorescence Technique for Measuring Piston Ring Oil Film Thickness
,”
ASME J. Lubr. Technol.
,
102
(
2
), pp.
165
170
.
8.
Hoult
,
D. P.
,
Lux
,
J. P.
,
Wong
,
V. W.
, and
Bilian
,
S. A.
,
1988
, “Calibration of Laser Fluorescence Measurements of Lubricant Film Thickness in Engines,”
SAE
Paper No. 881587.
9.
Wong
,
V.
, and
Hoult
,
D. P.
,
1991
, “Experimental Survey of Lubricant Film Characteristic and Oil Consumption in a Small Diesel Engine,”
SAE
Paper No. 910741.
10.
Richardson
,
D. E.
, and
Borman
,
G. L.
,
1991
, “Using Fiber Optics and Laser Fluorescence for Measuring Thin Oil Films With Application to Engines,”
SAE
Paper No. 912388.
11.
Shaw
,
B. T.
,
Hoult
,
D. P.
, and
Wong
,
V. W.
,
1992
, “Development of Engine Lubricant Film Thickness Diagnostics Using Fiber Optics and Laser Fluorescence,”
SAE
Paper No. 920651.
12.
Brown
,
M. A.
,
McCann
,
H.
, and
Thompson
,
D. M.
,
1993
, “Characterization of the Oil Film Behavior Between the Liner and Piston of a Heavy-Duty Diesel Engine,”
SAE
Paper No. 932784.
13.
Phen
,
R. V.
,
Richardson
,
D.
, and
Borman
,
G.
,
1993
, “Measurements of Cylinder Liner Oil Film Thickness in a Motored Diesel Engine,”
SAE
Paper No. 932789.
14.
Dearlove
,
J.
, and
Cheng
,
W. K.
,
1995
, “Simultaneous Piston Ring Friction and Oil Film Thickness Measurements in a Reciprocating Test Rig,”
SAE
Paper No. 952470.
15.
Stiyer
,
M. J.
, and
Ghandhi
,
J. B.
,
1997
, “Direct Calibration of LIF Measurements of the Oil Film Thickness Using the Capacitance Technique,”
SAE
Paper No. 972859.
16.
Froelund
,
K.
,
Scramm
,
J.
,
Noordzij
,
B.
,
Tian
,
T.
, and
Wong
,
V. W.
,
1997
, “An Investigation of the Cylinder Wall Oil Film Development During Warm-Up of an SI Engine Using Laser Induced Fluorescence,”
SAE
Paper No. 971699.
17.
Takiguchi
,
M.
,
Nakayama
,
K.
,
Furuhama
,
S.
, and
Yoshida
,
H.
,
1998
, “Variation of Piston Ring Oil Film Thickness in an Internal Combustion Engine—Comparison Between Thrust and Anti-Thrust Sides,”
SAE
Paper No. 980563.
18.
Arcoumanis
,
C.
,
Duszynski
,
M.
,
Lindenkamp
,
H.
, and
Preston
,
H.
,
1998
, “Measurements of the Lubricant Film Thickness in the Cylinder of a Firing Diesel Engine Using LIF,”
SAE
Paper No. 982435.
19.
Arcoumanis
,
C.
,
Duszynski
,
M.
,
Pyke
,
E.
, and
Preston
,
H.
,
1998
, “Cold-Start Measurements of the Lubricant Film Thickness in the Cylinder of a Firing Diesel Engine,”
SAE
Paper No. 982436.
20.
Inagaki
,
H.
,
Saito
,
A.
,
Murakami
,
M.
, and
Konomi
,
T.
,
1995
, “Development of Two Dimensional Oil Film Distribution Measurement System,”
SAE
Paper No. 952346.
21.
Thirouard
,
B.
,
Tian
,
T.
, and
Hart
,
D. P.
,
1998
, “Investigation of Oil Transport Mechanisms in the Piston Ring Pack of a Single Cylinder Diesel Engine, Using Two Dimensional Laser Induced Fluorescence,”
SAE
Paper No. 982658.
22.
Thirouard
,
B.
, and
Tian
,
T.
,
2003
, “Oil Transport in the Piston Ring Pack (Part I): Identification and Characterization of the Main Oil Transport Routes and Mechanisms,”
SAE
Paper No. 2003-01-1952.
23.
Picard
,
M.
,
Hidaka
,
H.
,
Tian
,
T.
,
Nishino
,
T.
,
Arai
,
E.
, and
Ohkubo
,
M.
,
2014
, “
Visualization of the Rotary Engine Oil Transport Mechanisms
,”
SAE Int. J. Engines
,
7
(3), pp.
1466
1476
.
24.
Baba
,
Y.
,
Suzuki
,
H.
,
Sakai
,
Y.
,
Wei
,
D. L. T.
,
Ishima
,
T.
, and
Obokata
,
T.
,
2017
, “PIV/LIF Measurements of Oil Film Behavior on the Piston in I. C. Engine,”
SAE
Paper No. 2007-24-0001.
25.
Wigger
,
S.
,
Füsser
,
H.
,
Fuhrmann
,
D.
,
Schulz
,
C.
, and
Kaiser
,
S.
,
2016
, “
Quantitative Two-Dimensional Measurement of Oil-Film Thickness by Laser-Induced Fluorescence in a Piston-Ring Model Experiment
,”
Appl. Opt.
,
55
(
2
), pp.
269
279
.
26.
Akalin
,
O.
, and
Newaz
,
G. M.
,
1998
, “A New Experimental Technique for Friction Simulation in Automotive Piston Ring and Cylinder Liners,”
SAE
Paper No. 981407.
You do not currently have access to this content.