Because an aircraft gas turbine operates under various flight conditions that change with altitude, flight velocity, and ambient temperature, the performance estimation that considers the flight conditions must be known before developing or operating the gas turbine. More so, for the unmanned aerial vehicle (UAV) where the engine is activated by an onboard engine controller in emergencies, the precise performance model including the estimated steady-state and transient performance data should be provided to the engine control system and the engine health monitoring system. In this study, a graphic user interface (GUI) type steady-state and transient performance simulation model of the PW206C turboshaft engine that was adopted for use in the Smart UAV was developed using SIMULINK for the performance analysis. For the simulation model, first the component maps including the compressor, gas generator turbine, and power turbine were inversely generated from the manufacturer’s limited performance deck data by the hybrid method. For the work and mass flow matching between components of the steady-state simulation, the state-flow library of SIMULINK was applied. The proposed steady-state performance model can simulate off-design point performance at various flight conditions and part loads, and in order to evaluate the steady-state performance model their simulation results were compared with the manufacturer’s performance deck data. According to comparison results, it was confirmed that the steady-state model agreed well with the deck data within 3% in all flight envelopes. In the transient performance simulation model, the continuity of mass flow (CMF) method was used, and the rotational speed change was calculated by integrating the excess torque due to the transient fuel flow change using the Runge–Kutta method. In this transient performance simulation, the turbine overshoot was predicted.
Skip Nav Destination
e-mail: young@ezgtc.com
e-mail: cdgong@chosun.ac.kr
e-mail: habari@paran.com
e-mail: leech@kari.re.kr
Article navigation
Research Papers
Steady-State and Transient Performance Modeling of Smart UAV Propulsion System Using SIMULINK
Jayoung Ki,
e-mail: young@ezgtc.com
Jayoung Ki
Easy Gas Turbine R&D Co., Ltd.
, 1112-Ho, Cention Building, 1 412 Dunsan-dong, Seo-gu, Daejeon 301-120, Republic of Korea
Search for other works by this author on:
Changduk Kong,
Changduk Kong
Department of Aerospace Engineering,
e-mail: cdgong@chosun.ac.kr
Chosun University
, 375 Seosuk-dong, Dong-gu, Gwangju 501-759, Republic of Korea
Search for other works by this author on:
Seonghee Kho,
Seonghee Kho
Department of Aerospace Engineering,
e-mail: habari@paran.com
Chosun University
, 375 Seosuk-dong, Dong-gu, Gwangju 501-759, Republic of Korea
Search for other works by this author on:
Changho Lee
Changho Lee
Smart UAV Development Center,
e-mail: leech@kari.re.kr
Korea Aerospace Research Institute
, 45 Eoeun-dong, Yuseong-gu, Daejeon 305-333, Republic of Korea
Search for other works by this author on:
Jayoung Ki
Easy Gas Turbine R&D Co., Ltd.
, 1112-Ho, Cention Building, 1 412 Dunsan-dong, Seo-gu, Daejeon 301-120, Republic of Koreae-mail: young@ezgtc.com
Changduk Kong
Department of Aerospace Engineering,
Chosun University
, 375 Seosuk-dong, Dong-gu, Gwangju 501-759, Republic of Koreae-mail: cdgong@chosun.ac.kr
Seonghee Kho
Department of Aerospace Engineering,
Chosun University
, 375 Seosuk-dong, Dong-gu, Gwangju 501-759, Republic of Koreae-mail: habari@paran.com
Changho Lee
Smart UAV Development Center,
Korea Aerospace Research Institute
, 45 Eoeun-dong, Yuseong-gu, Daejeon 305-333, Republic of Koreae-mail: leech@kari.re.kr
J. Eng. Gas Turbines Power. May 2009, 131(3): 031702 (8 pages)
Published Online: February 10, 2009
Article history
Received:
March 31, 2008
Revised:
April 9, 2008
Published:
February 10, 2009
Citation
Ki, J., Kong, C., Kho, S., and Lee, C. (February 10, 2009). "Steady-State and Transient Performance Modeling of Smart UAV Propulsion System Using SIMULINK." ASME. J. Eng. Gas Turbines Power. May 2009; 131(3): 031702. https://doi.org/10.1115/1.2982141
Download citation file:
Get Email Alerts
Cited By
Shape Optimization of an Industrial Aeroengine Combustor to reduce Thermoacoustic Instability
J. Eng. Gas Turbines Power
Dynamic Response of A Pivot-Mounted Squeeze Film Damper: Measurements and Predictions
J. Eng. Gas Turbines Power
Review of The Impact Of Hydrogen-Containing Fuels On Gas Turbine Hot-Section Materials
J. Eng. Gas Turbines Power
Effects of Lattice Orientation Angle On Tpms-Based Transpiration Cooling
J. Eng. Gas Turbines Power
Related Articles
Preliminary Gas Turbine Design Using the Multidisciplinary Design System MOPEDS
J. Eng. Gas Turbines Power (April,2004)
Model Development and Simulation of Transient Behavior of Heavy Duty Gas Turbines
J. Eng. Gas Turbines Power (July,2001)
Propulsion System Requirements for Long Range, Supersonic Aircraft
J. Fluids Eng (March,2006)
Computational Simulation of Gas Turbines: Part 1—Foundations of Component-Based Models
J. Eng. Gas Turbines Power (July,2000)
Related Chapters
Outlook
Closed-Cycle Gas Turbines: Operating Experience and Future Potential
Combined Cycle Power Plant
Energy and Power Generation Handbook: Established and Emerging Technologies
Performance Testing of Combined Cycle Power Plant
Handbook for Cogeneration and Combined Cycle Power Plants, Second Edition