Current research shows that the only hazardous air pollutant of significance emitted from large bore natural gas engines is formaldehyde A literature review on formaldehyde formation is presented focusing on the interpretation of published test data and its applicability to large bore natural gas engines. The relationship of formaldehyde emissions to that of other pollutants is described. Formaldehyde is seen to have a strong correlation to total hydrocarbon (THC) level in the exhaust. It is observed that the ratio of formaldehyde to THC concentration is roughly 1.0–2.5 percent for a very wide range of large bore engines and operating conditions. The impact of engine operating parameters, load, rpm, spark timing, and equivalence ratio, on formaldehyde emissions is also evaluated. [S0742-4795(00)01004-8]
Skip Nav Destination
Article navigation
October 2000
Technical Papers—Special Ice Section
Formaldehyde Formation in Large Bore Engines Part 2: Factors Affecting Measured CH2O
Daniel B. Olsen,
Daniel B. Olsen
Engines and Energy Conversion Laboratory, Department of Mechanical Engineering, Colorado State University, Fort Collins, CO 80523
Search for other works by this author on:
Charles E. Mitchell
Charles E. Mitchell
Engines and Energy Conversion Laboratory, Department of Mechanical Engineering, Colorado State University, Fort Collins, CO 80523
Search for other works by this author on:
Daniel B. Olsen
Engines and Energy Conversion Laboratory, Department of Mechanical Engineering, Colorado State University, Fort Collins, CO 80523
Charles E. Mitchell
Engines and Energy Conversion Laboratory, Department of Mechanical Engineering, Colorado State University, Fort Collins, CO 80523
Contributed by the Internal Combustion Engine Division of THE AMERICAN SOCIETY OF MECHANICAL ENGINEERS for publication in the ASME JOURNAL OF ENGINEERING FOR GAS TURBINES AND POWER. Manuscript received by the ICE Division November 6, 1998; final revision received by the ASME Headquarters December 29, 1999. Technical Editor: D. Assanis.
J. Eng. Gas Turbines Power. Oct 2000, 122(4): 611-616 (6 pages)
Published Online: December 29, 1999
Article history
Received:
November 6, 1998
Revised:
December 29, 1999
Citation
Olsen , D. B., and Mitchell, C. E. (December 29, 1999). "Formaldehyde Formation in Large Bore Engines Part 2: Factors Affecting Measured CH2O." ASME. J. Eng. Gas Turbines Power. October 2000; 122(4): 611–616. https://doi.org/10.1115/1.1290586
Download citation file:
Get Email Alerts
Temperature Dependence of Aerated Turbine Lubricating Oil Degradation from a Lab-Scale Test Rig
J. Eng. Gas Turbines Power
Multi-Disciplinary Surrogate-Based Optimization of a Compressor Rotor Blade Considering Ice Impact
J. Eng. Gas Turbines Power
Experimental Investigations on Carbon Segmented Seals With Smooth and Pocketed Pads
J. Eng. Gas Turbines Power
Related Articles
Formaldehyde Formation in Large Bore Natural Gas Engines Part 1: Formation Mechanisms
J. Eng. Gas Turbines Power (October,2000)
Improving the Efficiency of the Advanced Injection Low Pilot Ignited Natural Gas Engine Using Organic Rankine Cycles
J. Energy Resour. Technol (June,2008)
Prediction of Combustion Parameters, Performance, and Emissions in Compressed Natural Gas and Gasoline SI Engines
J. Eng. Gas Turbines Power (November,2008)
Sensitivity Analysis of NO x Formation Kinetics in Pilot-Ignited Natural Gas Engines
J. Eng. Gas Turbines Power (January,2007)
Related Proceedings Papers
Related Chapters
Lay-Up and Start-Up Practices
Consensus on Operating Practices for Control of Water and Steam Chemistry in Combined Cycle and Cogeneration
Physiology of Human Power Generation
Design of Human Powered Vehicles
A Simple Carburetor
Case Studies in Fluid Mechanics with Sensitivities to Governing Variables