Flow fields near the exit and the global performance parameters of the various types of axial flow fans are studied with Particle Image Velocimetry and a standard AMCA 210 flow bench. The fans used in this study included the shrouded, shroudless, and winglet-blade types. The velocity vectors, streamlines, vorticity contours, velocity distributions, and performances are presented and discussed. The flow patterns on the radial and axial planes show that a vortex always exists near the exit of the fans at various impeller angles. The experimental results demonstrate that the shrouded fan with winglets has the most stable flow field and the best fan performance.
Issue Section:
Technical Papers
1.
Eck
, B.
, 1973, Fans: Design and Operation of Centrifugal, Axial-Flow and Cross-Flow Fans
(translated and edited by Azad
, R. S.
, and Scott
, D. R.
), Pergamon
, Oxford.2.
Wallis
, R. A.
, 1983, Axial Flow Fans and Ducts
, Wiley
, New York.3.
Bleier
, F. P.
, 1998, Fan Handbook
, McGraw-Hill
, New York, pp. 13
–117
.4.
Eduardo
, B. M.
, Rafael
, B. T.
, and Carlos
, S.
, 1996, “Hot Wire Measurements During Rotating Stall in a Variable Pitch Axial Flow Fan
,” ASME Paper No. 96-GT-441.5.
Koop
, G. A.
, and Martinuzzi
, R. J.
, 2002, “The Measurement of Mean Flow Angles Between an Automotive Fan and Stator
,” Proceedings of the 2002 ASME Fluid Engineering Division
, ASME
, Canada, FEDSM2002-31431.6.
Sandra
, V. S.
, Rafael
, B. T.
, Carlos
, S. M.
, and Eduardo
, B. M.
, 2002, “Total Unsteadiness Downstream of an Axial Flow Fan with Variable Pitch Blades
,” ASME J. Fluids Eng.
0098-2202, 124
, pp. 280
–283
.7.
Ravindranath
, A.
, and Lakshminarayana
, B.
, 1980, “Mean Velocity and Decay Characteristics of the Near and Far-Wake of a Compressor Rotor Blade of Moderate Loading
,” ASME J. Eng. Power
0022-0825, 102
, pp. 535
–548
.8.
Myung
, H. J.
, and Baek
, J. H.
, 1999, “Mean Velocity Characteristics Behind a Forward Swept Axial-Flow Fan
,” JSME Int. J., Ser. B
1340-8054, 42
(3
), pp. 476
–488
.9.
Jang
, C. M.
, Furukawa
, M.
, and Inoue
, M.
, 2001, “Analysis of Vortical Flow Field in a Propeller Fan by LDV Measurements and LES-Part I: Three-Dimensional Vortical Flow Structures
,” ASME J. Fluids Eng.
0098-2202, 123
, pp. 748
–754
.10.
Du
, Z.
, Lin
, W.
, Zu
, X.
, and Zhao
, Y.
, 2002, “The Measurement of Three Dimensional Flow Field in an Axial Flow Fan Using PDA
,” Proceedings of the 2002 ASME Fluid Engineering Division
, ASME
, Canada, FEDSM2002-31098.11.
Estevadeordal
, J.
, Gogineni
, S.
, Copenhaver
, W.
, Bloch
, G.
, and Brendel
, M.
, 2000, “Flow Field in a Low-Speed Axial Fan: a DPIV Investigation
,” Exp. Therm. Fluid Sci.
0894-1777, 23
, pp. 11
–21
.12.
Lee
, S. J.
, Choi
, J.
, and Yoon
, J. H.
, 2003, “Phase-Averaged Velocity Filed Measurements of Flow Around an Isolated Axial-Fan Model
,” ASME J. Fluids Eng.
0098-2202, 125
, pp. 1067
–1072
.13.
Shimada
, K.
, Kimura
, K.
, and Watanabe
, H.
, 2003, “A Study of Radiator Cooling Fan with Labyrinth Seal
,” Society of Automotive Engineers of Japan
, 24
, pp. 431
–439
.14.
Oh
, K. J.
, and Kang
, S. H.
, 1999, “A Numerical Investigation of the Dual performance Characteristics of a Small Propeller Fan Using Viscous Flow Calculations
,” Comput. Fluids
0045-7930, 28
, pp. 815
–823
.15.
Stinnes
, W. H.
, and von Backstrom
, T. W.
, 2002, “Effect of Cross-Flow on the Performance of Air-Cooled Heat Exchanger Fans
,” Appl. Therm. Eng.
1359-4311, 22
, pp. 1403
–1415
.16.
Mizuno
, T.
, and Kikuchi
, K.
, 1990, “Characteristic of Axial Flow Fan with Diagonal Flow Hub
,” SAE Trans.
0096-736X, 99
(6
), pp. 49
–55
.17.
Mei
, R.
, 1996, “Velocity Fidelity of Flow Tracer Particles
,” Exp. Fluids
0723-4864, 22
(1
), pp. 1
–13
.18.
Keane
, R. D.
, and Adrian
, R. J.
, 1992, “Theory of Cross-Correlation Analysis of PIV Images
,” Appl. Sci. Res.
0003-6994, 49
(2
), pp. 191
–215
.19.
Keane
, R. D.
, and Adrian
, R. J.
, 1990, “Optimization of Particle Image Velocimeters Part I: Double Pulsed Systems
,” Meas. Sci. Technol.
0957-0233, 1
(11
), pp. 1202
–1215
.20.
Chung
, D. L.
, 2000, “Development of Design Methodology for Cooling System of a Disk Array
,” Master thesis, National Taiwan University of Science and Technology, Taiwan, pp. 11
–13
.21.
Wright
, T.
, 1999, Fluid Machinery: Performance, Analysis, and Design
, CRC Press
, Boca Raton, pp. 41
–70
.22.
Davis
, J. C.
, 1986, Statistics and Data Analysis in Geology
, Wiley
, New York, pp. 28
–34
.23.
24.
Spedding
, G. R.
, and Rignot
, E. J.
, 1993, “Performance Analysis and Application of Grid Interpolation Techniques for Fluid Flows
,” Exp. Fluids
0723-4864, 15
, pp. 417
–430
.25.
Huang
, R. F.
, and Tsai
, F. C.
, 2001, “Observations of Swirling Flows behind Circular Discs
,” AIAA J.
0001-1452, 39
(6
), pp. 1106
–1112
.26.
Andercon
, J. D.
, 1991, Fundamentals of Aerodynamics
, McGraw-Hill
, New York, pp. 316
–317
.27.
Houghton
, E. L.
, and Carpenter
, P. W.
, 1993, Aerodynamics for Engineering Students
, Edward Arnold
, London, pp. 315
–317
.Copyright © 2006
by American Society of Mechanical Engineers
You do not currently have access to this content.
