Considering the large variations of working fluid's properties in near-critical region, this paper presents a thermodynamic analysis of the performance of organic Rankine cycle in near-critical condition (NORC) subjected to the influence of evaporation temperature. Three typical organic fluids are selected as working fluids. They are dry R236fa, isentropic R142b, and wet R152a, which are suited for heat source temperature from 395 to 445 K. An iteration calculation method is proposed to calculate the performance parameters of organic Rankine cycle (ORC). The variations of superheat degree, specific absorbed heat, expander inlet pressure, thermal efficiency, and specific net power of these fluids with evaporation temperature are analyzed. It is found that the working fluids in NORC should be superheated because of the large slope variation of the saturated vapor curve in near-critical region. However, the use of dry R236fa or isentropic R142b in NORC can be accepted because of the small superheat degree. The results also indicate that a small variation of evaporation temperature requires a large variation of expander inlet pressure, which may make the system more stable. In addition, due to the large decrease of latent heat in near-critical region, the variation of specific absorbed heat with evaporation temperature is small for NORC. Both specific net power and thermal efficiency for the fluids in NORC increase slightly with the rise of the evaporation temperature, especially for R236fa and R142b. Among the three types of fluids, dry R236fa and isentropic R142b are better suited for NORC. The results are useful for the design and optimization of ORC system in near-critical condition.
Skip Nav Destination
Article navigation
Research-Article
Effect of Evaporation Temperature on the Performance of Organic Rankine Cycle in Near-Critical Condition
Yuping Wang,
Yuping Wang
Key Laboratory of Power Machinery
and Engineering,
Ministry of Education,
Shanghai Jiao Tong University,
800 Dongchuan Road,
Minhang District,
Shanghai 200240, China
e-mail: linerw@sjtu.edu.cn
and Engineering,
Ministry of Education,
Shanghai Jiao Tong University,
800 Dongchuan Road,
Minhang District,
Shanghai 200240, China
e-mail: linerw@sjtu.edu.cn
Search for other works by this author on:
Xiaoyi Ding,
Xiaoyi Ding
Key Laboratory of Power Machinery
and Engineering,
Ministry of Education,
Shanghai Jiao Tong University,
800 Dongchuan Road,
Minhang District,
Shanghai 200240, China
e-mail: dingxiaoyi_frank@126.com
and Engineering,
Ministry of Education,
Shanghai Jiao Tong University,
800 Dongchuan Road,
Minhang District,
Shanghai 200240, China
e-mail: dingxiaoyi_frank@126.com
Search for other works by this author on:
Lei Tang,
Lei Tang
Key Laboratory of Power Machinery
and Engineering,
Ministry of Education,
Shanghai Jiao Tong University,
800 Dongchuan Road,
Minhang District,
Shanghai 200240, China
e-mail: tangleisjtu@163.com
and Engineering,
Ministry of Education,
Shanghai Jiao Tong University,
800 Dongchuan Road,
Minhang District,
Shanghai 200240, China
e-mail: tangleisjtu@163.com
Search for other works by this author on:
Yiwu Weng
Yiwu Weng
Key Laboratory of Power Machinery
and Engineering,
Ministry of Education,
Shanghai Jiao Tong University,
800 Dongchuan Road,
Minhang District,
Shanghai 200240, China
e-mail: ywweng@sjtu.edu.cn
and Engineering,
Ministry of Education,
Shanghai Jiao Tong University,
800 Dongchuan Road,
Minhang District,
Shanghai 200240, China
e-mail: ywweng@sjtu.edu.cn
Search for other works by this author on:
Yuping Wang
Key Laboratory of Power Machinery
and Engineering,
Ministry of Education,
Shanghai Jiao Tong University,
800 Dongchuan Road,
Minhang District,
Shanghai 200240, China
e-mail: linerw@sjtu.edu.cn
and Engineering,
Ministry of Education,
Shanghai Jiao Tong University,
800 Dongchuan Road,
Minhang District,
Shanghai 200240, China
e-mail: linerw@sjtu.edu.cn
Xiaoyi Ding
Key Laboratory of Power Machinery
and Engineering,
Ministry of Education,
Shanghai Jiao Tong University,
800 Dongchuan Road,
Minhang District,
Shanghai 200240, China
e-mail: dingxiaoyi_frank@126.com
and Engineering,
Ministry of Education,
Shanghai Jiao Tong University,
800 Dongchuan Road,
Minhang District,
Shanghai 200240, China
e-mail: dingxiaoyi_frank@126.com
Lei Tang
Key Laboratory of Power Machinery
and Engineering,
Ministry of Education,
Shanghai Jiao Tong University,
800 Dongchuan Road,
Minhang District,
Shanghai 200240, China
e-mail: tangleisjtu@163.com
and Engineering,
Ministry of Education,
Shanghai Jiao Tong University,
800 Dongchuan Road,
Minhang District,
Shanghai 200240, China
e-mail: tangleisjtu@163.com
Yiwu Weng
Key Laboratory of Power Machinery
and Engineering,
Ministry of Education,
Shanghai Jiao Tong University,
800 Dongchuan Road,
Minhang District,
Shanghai 200240, China
e-mail: ywweng@sjtu.edu.cn
and Engineering,
Ministry of Education,
Shanghai Jiao Tong University,
800 Dongchuan Road,
Minhang District,
Shanghai 200240, China
e-mail: ywweng@sjtu.edu.cn
1Corresponding author.
Contributed by the Advanced Energy Systems Division of ASME for publication in the JOURNAL OF ENERGY RESOURCES TECHNOLOGY. Manuscript received September 9, 2015; final manuscript received December 9, 2015; published online January 5, 2016. Assoc. Editor: Kau-Fui Wong.
J. Energy Resour. Technol. May 2016, 138(3): 032001 (8 pages)
Published Online: January 5, 2016
Article history
Received:
September 9, 2015
Revised:
December 9, 2015
Citation
Wang, Y., Ding, X., Tang, L., and Weng, Y. (January 5, 2016). "Effect of Evaporation Temperature on the Performance of Organic Rankine Cycle in Near-Critical Condition." ASME. J. Energy Resour. Technol. May 2016; 138(3): 032001. https://doi.org/10.1115/1.4032238
Download citation file:
Get Email Alerts
Cited By
Fuel Consumption Prediction in Dual-Fuel Low-Speed Marine Engines With Low-Pressure Gas Injection
J. Energy Resour. Technol (December 2024)
A Semi-Analytical Rate-Transient Analysis Model for Fractured Horizontal Well in Tight Reservoirs Under Multiphase Flow Conditions
J. Energy Resour. Technol (November 2024)
Experimental Investigation of New Combustion Chamber Geometry Modification on Engine Performance, Emission, and Cylinder Liner Microstructure for a Diesel Engine
J. Energy Resour. Technol (December 2024)
Downdraft Gasification for Biogas Production: The Role of Artificial Intelligence
J. Energy Resour. Technol (December 2024)
Related Articles
Generation of Complex Energy Systems by Combination of Elementary Processes
J. Energy Resour. Technol (November,2018)
A Novel Pinch Point Design Methodology Based Energy and Economic Analyses of Organic Rankine Cycle
J. Energy Resour. Technol (May,2018)
Performance Analysis of a New ORC-VCC System With Mechanical Overheating and Correlation Fitting of Most Important System Parameter
J. Thermal Sci. Eng. Appl (January,2024)
Compost Waste Heat to Power Organic Rankine Cycle Design and Analysis
J. Energy Resour. Technol (October,2023)
Related Proceedings Papers
Related Chapters
Introduction I: Role of Engineering Science
Fundamentals of heat Engines: Reciprocating and Gas Turbine Internal Combustion Engines
Physiology of Human Power Generation
Design of Human Powered Vehicles
Compressive Deformation of Hot-Applied Rubberized Asphalt Waterproofing
Roofing Research and Standards Development: 10th Volume