Abstract

A performance evaluation for a residential window air conditioning system with microchannel condensers has been performed. First, a series of wind-tunnel calorimeter tests were conducted for two different prototype microchannel heat exchangers. The measured heat transfer and pressure drop characteristics for the heat exchangers were then compared to calculated value for four conventional finned round-tube designs, which were obtained using a validated simulation model for identical air and refrigerant inlet conditions. Finally, two prototype microchannel condensers are installed in the system and system performance tests were conducted. System characteristics such as capacity, energy efficiency ratio, and suction and discharge pressures and temperatures are presented, and compared with those for the conventional system. Refrigerant charge requirements for a window air conditioner with a microchannel condenser can be decreased by 35 percent compared to the conventional baseline system. The condenser core volume and weight can be reduced by 55 and 35 percent, respectively.

Issue Section:
Technical Papers
Keywords:
air conditioning, performance evaluation, wind tunnels, heat exchangers, simulation, testing
Topics:
Condensers (steam plant), Heat exchangers, Microchannels, Refrigerants, Performance evaluation
1.
Rosenquist
,
G.
,
1999
, “
Window-Type Room Air Conditioners
,”
ASHRAE J.
,
41
, No.
1
, pp.
31
–
35
.
2.
Shah, R. K., 1978, “Compact Heat Exchanger Surface Selection Methods,” Proc. 6th Int. Heat Transfer Conference, Toronto, 4, pp. 193–199.
3.
Cowell
,
T. A.
,
1990
, “
A General Method for the Comparison of Compact Heat Transfer Surface
,”
J. Heat Transfer
,
112
, pp.
288
–
294
.
4.
DeJong
,
N. C.
, and
Jacobi
,
A. M.
,
1997
, “
An Experimental Study of Flow and Heat transfer in Parallel-Plate Arrays
,”
Int. J. Heat Mass Transf.
,
40
, No.
6
, pp.
1365
–
1378
.
5.
Kim
,
N. H.
,
Youn
,
B.
, and
Webb
,
R. L.
,
1999
, “
Air-Side Heat Transfer and Friction Correlations for Plain Fin-and-Tube Heat Exchangers With Staggered Tube Arrangements
,”
J. Heat Transfer
,
121
, pp.
662
–
667
.
6.
Kang
,
H. C.
, and
Kim
,
M. H.
,
1999
, “
Effect of Strip Location on the Air-Side Pressure Drop and Heat Transfer in Strip Fin-and-Tube Heat Exchanger
,”
Int. J. Refrig.
,
22
, pp.
302
–
312
.
7.
Webb
,
R. L.
, and
Jung
,
S.-H.
,
1992
, “
Air-Side Performance of Enhanced Brazed Aluminum Heat Exchangers
,”
ASHRAE Trans.
,
98
, Pt. 2, pp.
391
–
401
.
8.
Critoph
,
R. E.
,
Holland
,
M. K.
, and
Tyrner
,
L.
,
1996
, “
Contact Resistance in Air-Cooled Plate Fin-Tube Air-conditioning Condensers
,”
Int. J. Refrig.
,
19
, No.
6
, pp.
400
–
406
.
9.
Rugh, J. P., Pearson, J. T., and Ramadhyani, S., 1992, “A Study of a Very Compact Heat Exchanger Used for Passenger Compartment Heating in Automobiles,” Symposium Series, ASME HTD-Vol. 201, pp. 15–24.
10.
Chang, Y. J., Wang, C. C., Shyu, R. J., and Hu, Y. Z., 1995, “Performance Comparison Between Automotive Flat Tube Condenser and Round Tube Condenser,” ASME/JSME Thermal Engineering Conference, 4, pp. 331–336.
11.
Kirkwood, A. C. and Bullard, C. W., 1999, “Modeling, Design, Testing of a Microchannel Split-System Air Conditioner,” ACRC TR-49, University of Illinois at Urbana-Champaign.
12.
ANSI/ASHRAE Standard 41.1-1986 (RA 91), 1991, Standard Method for Temperature Measurement, ASHRAE, Atlanta, GA.
13.
Youn
,
B.
,
Kim
,
Y. S.
, and
Park
,
H. Y.
,
1996
, “
Performance Evaluation of Cross Flow Fin-Tube Heat Exchangers
,”
Air Conditioning and Refrigeration, The Society of Air-Conditioning and Refrigerating Engineers of Korea (SAREK)
,
25
, No.
2
, pp.
151
–
160
.
14.
Domanski, P. A., 1982, “Computer Modeling and Prediction of Performance of an Air Source Heat Pump with a Capillary Tube,” Ph.D. thesis, The Catholic University of America, Washington, DC.
15.
Kim
,
M.-H.
, and
Bullard
,
C. W.
,
2002
, “
Air-Side Thermal Hydraulic Performance of Multi-Louvered Fin Aluminum Heat Exchangers
,”
Int. J. Refrig.
,
25
, No.
3
, pp.
413
–
423
.
16.
Mulroy
,
W. J.
, and
Didion
,
D. A.
,
1985
, “
Refrigeration Migration in a Split-Unit Air Conditioner
,”
ASHRAE Trans.
,
91
, Part 1A, pp.
193
–
206
.
17.
Tanaka
,
N.
,
Ikekuchi
,
M.
, and
Yamanaka
,
G.
,
1982
, “
Experimental Study on the Dynamic Characteristics of a Heat Pump
,”
ASHRAE Trans.
,
88
, Pt. 2, pp.
323
–
331
.
18.
Kim
,
M.-H.
, and
Bullard
,
C. W.
,
2001
, “
Dynamic Characteristics of a R410A Split Air Conditioning System
,”
Int. J. Refrig.
,
24
, pp.
652
–
659
.
Copyright © 2002
 by ASME
You do not currently have access to this content.