This paper deals with the problem of measuring the inertia tensor of rigid bodies. An original approach is adopted, different from classical modal analysis techniques. The rigid body is forced by a spatial mechanism to rotate around different axes. Once the mechanism is calibrated, i.e., its inertia and stiffness matrices are known, the inertia tensor of the rigid body may be determined by measuring the frequencies of the small oscillations around the selected axes and then solving a least-squares identification problem. Two prototypes of the spatial mechanism were built. The first was used to perform tests and to measure the inertia tensor of some compressors for domestic refrigeration. The second was constructed to measure the inertia tensor of large mechanical systems.

1.
Buyanov
 
E. V.
,
1991
, “
Device for Measuring the Inertia Tensor of a Rigid Body
,”
Measurement Techniques
, Vol.
34
, No.
6
, pp.
585
589
.
2.
Conti
 
P.
, and
Bretl
 
J.
,
1989
, “
Mount Stiffnesses and Inertia Properties from Modal Test Data
,”
ASME Journal of Vibration, Acoustics, Stress and Reliability in Design
, Vol.
111
, pp.
134
138
.
3.
Cossalter, V., Da Lio, M., Lot, R., and Fabbri, L., 1998, “A General Method for the Evaluation of Vehicle Manoeuvrability with Special Emphasis on Motorcycles,” Vehicle System Dynamics, to appear.
4.
Durisek
 
N. J.
,
Heydinger
 
G. J.
,
Chrstos
 
J. P.
, and
Guenther
 
D. A.
,
1997
, “
Land Vehicle Roll/Yaw Product of Inertia Measurement
,”
ASME JOURNAL OF DYNAMIC SYSTEMS, MEASUREMENT, AND CONTROL
, Vol.
119
, pp.
212
216
.
5.
Fregolent, A., Sestieri, A., and Falzetti, M., 1992, “Identification of Rigid Body Inertia Properties from Experimental Frequency Response,” Proceedings, 10th International Modal Analysis Conference, San Diego, CA, Vol. 1, pp. 219–225.
6.
Gentile
 
A.
,
Mangialardi
 
L.
,
Mantriota
 
G.
, and
Trentadue
 
A.
,
1995
, “
Measurement of the Inertia Tensor: An Experimental Proposal
,”
Measurement
, Vol.
16
, pp.
241
254
.
7.
Gupta
 
V. K.
,
1973
, “
Kinematic Analysis of Plane and Spatial Mechanisms
,”
ASME Journal of Engineering for Industry
, Vol.
95
, pp.
481
486
.
8.
Pandit, S., Hu, Z. Q., and Yao, Y. X., 1992, “Experimental Technique for Accurate Determination of Rigid Body Characteristics,” Proceedings, 10th International Modal Analysis Conference, San Diego, CA, Vol. 1, pp. 307–311.
9.
Pandit
 
S.
,
Hu
,
1994
, “
Determination of Rigid Body Characteristics from Time Domain Modal Test Data
,”
Journal of Sound and Vibration
, Vol.
177
(
1
), pp.
31
41
.
10.
Toivola, J., and Nuutila, O., 1993, “Comparison of Three Methods for Determining Rigid Body Inertia Properties from Frequency Response Functions,” Proceedings, 11th International Modal Analysis Conference, Kissimmee, FL, Vol. 2, pp. 1126–1132.
This content is only available via PDF.
You do not currently have access to this content.