The design and performance evaluation of an airbag system capable of decelerating masses in the range of hundreds to thousands of kilograms with impact velocities in the range of tens to hundreds of kilometers per hour is presented. First, a simplified incompressible flow analysis of the airbag is utilized to derive the orifice venting area corresponding to the ideal deceleration for a given impact velocity and package mass. Second, testing with a small-scale model found three distinct control intervals during the deceleration. Finally, a full-scale airbag system was constructed and data is presented on the deceleration, deceleration force, deceleration velocity, airbag stopping power, and overall performance. The deceleration was experimentally optimized for a single impact velocity and package mass and an approximate correction factor was developed to predict the actual air venting required for each of the three control intervals in order to achieve the optimum deceleration for any impact velocity and package mass.

Issue Section:
Technical Papers
Topics:
Airbags, Design, Testing, Flow (Dynamics), Performance evaluation
1.
Burton, T. D., 1994, Introduction to Dynamic System Analysis, McGraw-Hill, pp.85–88.
2.
Cooper, M. G., 1983, “A simple Drop Table for Fractional Gravity—Design and Instrumentation,” Int. J. Heat Mass Transfer, pp. 1087–1088.
3.
Dittus, H., 1991, Drop Tower ’Bremen’: a weightlessness laboratory on Earth, Endeavour, Vol. 15, No. 2.
4.
Hazelrigg, G. A., and Reynolds, J. M., 1986, Opportunities for Academic Research in a Low-Gravity Environment, Vol. 108, Progress in Astronautics and Aeronautics V. 108, American Institute of Aeronautics and Astronautics, Inc., New York, NY.
5.
Koster, J. N and Sani, R. L., 1990, Low-Gravity fluid Dynamics and Transport Phenomena, American Institute of Aeronautics and Astronautics, pp. 15–72
6.
Lekan, Neumann, and Sotos, 1992, “Capabilities and Constraints of NASA’s Ground-Based Reduced Gravity Facilities,” NASA Conference Publication 10113.
7.
Liu, Chun-Hui., 1993, “Microgravity Fluid Mechanics Drop Tower Facility,” Microgravity Q., No, 2–4, pp. 277–279.
8.
Robertson and Crowe, 1990, Engineering Fluid Mechanics, Fourth Edition, Houghton Mifflin.
9.
Snyder, Trevor J., 1993, “WSU 2.1 Second Microgravity Drop Tower, Design, Construction, and Performance,” MS thesis, Dec.
10.
Viano, D. C., 1987, Passenger Car Inflatable Restraint Systems: A Compendium of Published Safety Research, Society of Automotive Engineers, Inc.
This content is only available via PDF.
Copyright © 1997
 by The American Society of Mechanical Engineers
You do not currently have access to this content.