Skip Nav Destination
1-5 of 5
Keywords: total pressure lossClose
Proc. ASME. GT2021, Volume 5A: Heat Transfer — Combustors; Film Cooling, V05AT12A001, June 7–11, 2021
Paper No: GT2021-58451
... delivering tube and out of the film hole, adiabatic film cooling effectiveness distributions as well as the total pressure loss coefficient were investigated. The delivering tube of alternating elliptical film hole consists of two straight sections and a transition section. In the straight sections...
Proc. ASME. GT2020, Volume 2A: Turbomachinery, V02AT32A016, September 21–25, 2020
Paper No: GT2020-14366
... at the design and off-design conditions. The simulation results show that optimal endwall design can provide 3.08% reduction of the total pressure loss at the design condition. The reduction of pressure loss obtained is mainly below 24%span with the size of the high loss region being effectively reduced...
Proc. ASME. GT2020, Volume 7A: Heat Transfer, V07AT15A034, September 21–25, 2020
Paper No: GT2020-16115
.... The turning internal radius has stronger effect than turning angle. With higher jet Reynolds number, both the heat transfer and total pressure loss increase dramatically, and the effects of geometrical parameters are clearer. turbine blade internal cooling Reynolds number Nusselt number total...
Proc. ASME. GT2019, Volume 5A: Heat Transfer, V05AT11A005, June 17–21, 2019
Paper No: GT2019-90421
... film cooling , which is pushed by centrifugal force and minimizes the mixing with spent cooling air. Namely, the greatly organized coolant flow generates higher cooling effectiveness and lower coolant demand. Both the Nusselt number on the channel surfaces and total pressure loss increase significantly...
Proc. ASME. GT2013, Volume 3C: Heat Transfer, V03CT17A001, June 3–7, 2013
Paper No: GT2013-94209
... parameters in the design of a low-pressure-loss, high-performance combustion system. With rising of the inlet Mach number of the combustor, dramatically increasing of the diffuser total pressure loss and flow separation. So a new distributor diffuser was designed. In this paper preliminary results from...