0
TECHNICAL BRIEFS

Sensitivity Analysis of the Conical-Shaped Equivalent Model of a Bolted Joint

[+] Author and Article Information
Noah D. Manring

Mechanical and Aerospace Engineering Department, University of Missouri–Columbia, Columbia, MO 65211

J. Mech. Des 125(3), 642-646 (Sep 04, 2003) (5 pages) doi:10.1115/1.1587747 History: Revised September 01, 2002; Revised February 01, 2003; Online September 04, 2003
Copyright © 2003 by ASME
Your Session has timed out. Please sign back in to continue.

References

Figures

Grahic Jump Location
Schematic of a bolted joint and its conical-shaped equivalent system
Grahic Jump Location
Dimensionless spring rate of the clamped material
Grahic Jump Location
Sensitivity of the bolted joint to small changes in the washer diameter, d⁁w. The cone angle ψ is 30 deg for this plot.
Grahic Jump Location
Sensitivity of the bolted joint to small changes in l over d ratio, β. The cone angle ψ is 30 deg for this plot.
Grahic Jump Location
Sensitivity of the bolted joint to small changes in the cone angle, ψ. The nominal cone angle is 30 deg for this plot.
Grahic Jump Location
A plot of the error, ε, from Eq. (8). To make this plot, k⁁m was calculated using ψ=35 deg and k⁁mo was calculated using ψ=30 deg.

Tables

Errata

Discussions

Some tools below are only available to our subscribers or users with an online account.

Related Content

Customize your page view by dragging and repositioning the boxes below.

Related Journal Articles
Related eBook Content
Topic Collections

Sorry! You do not have access to this content. For assistance or to subscribe, please contact us:

  • TELEPHONE: 1-800-843-2763 (Toll-free in the USA)
  • EMAIL: asmedigitalcollection@asme.org
Sign In