0
RESEARCH PAPERS

Dynamic Load Analysis of Spur Gears Using a New Tooth Profile

[+] Author and Article Information
K. Y. Yoon, S. S. Rao

School of Mechanical Engineering, Purdue University, West Lafayette, IN 47907-1288

J. Mech. Des 118(1), 1-6 (Mar 01, 1996) (6 pages) doi:10.1115/1.2826851 History: Received October 01, 1994; Revised June 01, 1995; Online December 11, 2007

Abstract

A novel method was presented by the authors to minimize the static transmission error using cubic splines (C.S.) for gear tooth profile. A reduction in the transmission error is expected to reduce the gear vibration and noise by lowering the dynamic tooth load in a meshing cycle. To establish this fact, a dynamic analysis of the gear drive with involute tooth and modified tooth profiles (using C.S.) is performed. For this, first the tooth deformation is found and then the tooth dynamic load is determined for all reasonable speeds. A parametric study is conducted to establish the superiority of the C.S. based gear profile over the involute profile as well as the other profiles based on the use of linear and parabolic tip reliefs.

Copyright © 1996 by The American Society of Mechanical Engineers
Your Session has timed out. Please sign back in to continue.

References

Figures

Tables

Errata

Discussions

Some tools below are only available to our subscribers or users with an online account.

Related Content

Customize your page view by dragging and repositioning the boxes below.

Related Journal Articles
Related eBook Content
Topic Collections

Sorry! You do not have access to this content. For assistance or to subscribe, please contact us:

  • TELEPHONE: 1-800-843-2763 (Toll-free in the USA)
  • EMAIL: asmedigitalcollection@asme.org
Sign In