0
RESEARCH PAPERS

A Synthesis Procedure for Design of 3-R Planar Robotic Workcells in Which Large Rotations Are Required at the Workpiece

[+] Author and Article Information
J. K. Davidson

Department of Mechanical and Aerospace Engineering, Arizona State University, Tempe, AZ 85287-6106

J. Mech. Des 114(4), 547-558 (Dec 01, 1992) (12 pages) doi:10.1115/1.2917042 History: Received March 01, 1990; Revised June 01, 1991; Online June 02, 2008

Abstract

A new method is developed for determining both a satisfactory location of a workpiece and a suitable mounting-angle of the tool for planar 3-R robots that can provide dexterous workspace. The method is an adaptation of traditional techniques of linkage synthesis, and it is particularly well-suited to applications in which the motion-trajectory requires large rotations of the end-effector. It is determined that, when the trajectory requires that the end-effector rotate a full turn at just two locations and when the critical joint in the robot is rotatable by one turn, then the radial location of the workpiece is fixed in the workcell but its angular location is not fixed. When the mounting-angle of the tool is also a variable, the method accommodates trajectories in which the tool must rotate a full turn at three locations on the workpiece. The method can be applied not only to planar robots with three hinge-joints, but also to spatial robots, each with a planar 3-R module, when the principal attitudinal excursions of the trajectory are all about a set of parallel axes. Variables are identified, for both the motion-trajectory and the workpiece itself, which strongly affect the design of the workcell and the time for it to complete a motion-trajectory. Example problems illustrate the method. The new method is suggested as an alternative to the existing methods of computer science for motion-planning.

Copyright © 1992 by The American Society of Mechanical Engineers
Topics: Design
Your Session has timed out. Please sign back in to continue.

References

Figures

Tables

Errata

Discussions

Some tools below are only available to our subscribers or users with an online account.

Related Content

Customize your page view by dragging and repositioning the boxes below.

Related Journal Articles
Related eBook Content
Topic Collections

Sorry! You do not have access to this content. For assistance or to subscribe, please contact us:

  • TELEPHONE: 1-800-843-2763 (Toll-free in the USA)
  • EMAIL: asmedigitalcollection@asme.org
Sign In